Some readers says that while is inserting flash drive in USB port. The system didn’t recognize it how could we overcome it.

First of all we should know the two types of USB ports.

USB 1.1: This is the first type of USB. It designed as per the speed of transferring 1.5mb/sec data’s. This is designed instead of serial and parallel port for the use of USB port. This is basically used only for connecting mouse and keyboard. System would be struggled for data overloading.

USB 2.0: This kind of USB ports is used for large scale into data transfer. More readers ask that how to identify these two kind of USB ports. To identify the model use the following commands. Start=>My computer=> properties. And click Hardware tab after than select Device Manager. Now you got the list. In that list select the plus symbol that is located after “Universal Serial Bus controllers” if your system have USB 1.1 mean it displays as “Host controller (or) Open Host Controller”. Else USB 2.0 is used mean it displays like.” Enhanced host controller (or) USB 2.0 controller.

Your windows operating system says that the connected USB get speeded. When you are connecting the high speed USB to logo speed USB port of the system, but most of the reader saying that while connecting the USB device to the system. The device was not getting detected. Commonly while inserting an USB device to the system. Window XP will say new hardware found. This message will display in the hard disk. While inserting the USB device it will get auto play, and enquire whether to open the files as file (Or) audio format (Or) video format? It assigns a drive letter for it. If all the details mentioned above had not displayed means the inserted device had not matched with your operating system. You can solve this by doing below.

Go to Start => control panel =>Administrative Tools and click in administrative tool. After that double click on Computer Management.
In that left side select Disk Management, at the right side a drive displays with the name of a removable drive. This is the drive thus containing to same name of already using drive.
To change it right click on the while bar then a got a list.
Now select “change drive letters and paths”.
Now you can select the letter that you want. Click the “change” option.
The letter that you selected it should be already used one.
After finishing this you should get a warning message.
Now click ok to it.
Now close the computer management console while clicking the My computer icon.
You can see the USB drive’s letter.

We face more problems on problem on using USB port. Some part may become in accessible due to the power shortage of computer. These kinds of problems happen on USB 1.1 ports only. These problems happen only on windows 2000 and the before edition while getting these kind of problems. We just disconnect the instruments after that connect one by one.

Now a days the new version computer consists of at-least four USB ports. Two ports are fixed in backside and the remaining two parts are fixed in front side. Windows XP packages will manage these ports without any problems.